The Grasshopper workshop that I attended at Construct3D was held at the Innovation Co-Lab at Duke University. The facilities is open to all Duke students to use and you can just walk in and use the printers or you can send print files to the Ultimakers and then keep tabs remotely on your print using the webcam that are attached to each printer. This place was off the hook! There was a small locked back lab that had a Tormach 440 and some higher end printers. It was cool to see a MarkForged "in the wild". Tom Burtonwood and I looked around the space after the workshop was over. It was quite the space!
No comments:
Post a Comment