I just made this slick laser etched drill bit/ tap drill chart for the campus studio.
Showing posts with label laser engraving. Show all posts
Showing posts with label laser engraving. Show all posts
Monday, September 3, 2018
Friday, October 20, 2017
laser engraving printing plates
I've been laser engraving printing plates for on one my colleagues Scott Ludwig. We've been testing different resists. Scott prepped several plates for me and then I prepped a few plates using Rustoleum Flat Khaki spray paint. The Rustoleum burns very cleanly and it proving to get good results.
Friday, May 15, 2015
laser cured powder coat on acrylic
Lionel Rocheleau is one of my lab technicians in the DCRL. This semester he was interested in doing some laser cutter investigations during his laser technician "down time". We discussed the use of powder coat with laser engraving on acrylic and he made the above samples. The piece of acrylic is first engraved with a raster pattern at standard speed/power and then powder coat power is placed on the piece and the operation is re-run but at a higher speed and lighter power. The result is a cured/fused powder on top of the acrylic. The results are really quite nice and it appears to look like colored acrylics. He also experimented with layering the powder to see what effects he could achieve. The ability to precisely "color" ares on the acrylic is so great. Lionel is going to work toward his completion of a BA in Digital Fabrication and Design. He has just completed his Art and Design First Year course work so I look forward to seeing his progress in the DCRL.
Labels:
dcrl,
digital craft,
digital fabrication,
laser cutter,
laser engraving
Tuesday, December 23, 2014
laser engraving stainless steel w/ plaster
So Bryan and I tried the airbrush and the plaster of paris particle size was too large to go through the air brush even after considerable thinning. I finally tried the solution with a cheap detail gun and it worked great. Bryan applied one coat and then used the heat gun to dry the piece rapidly. Then he applied a second coat and repeated the heat application with the heat gun. The resulting surface was quite even. We set up the Rhino file and finalized our settings using the afore mentioned settings. It worked like a charm! Check it out.
I believe this is working due to the chromium content of the stainless steel. Stainless has a passivation layer that is thin and completely transparent; Chromium oxide. When combined with calcium sulfate (plaster) along with the heat from the laser and potential water from the surrounding air, you end up with calcium oxide and chromium sulfate. Chromium sulfate creates the mark and the calcium oxide washes off. Again this is my basic premise and understanding of what’s occurring here.
If you slow the laser down, it will create a darker etch/mark. Higher wattage lasers should be able to reduce the power a bit from my 100% power setting on the Epilog Zing 40 watt.
Labels:
laser cutter,
laser engraving,
stainless steel,
Zing
Subscribe to:
Posts (Atom)