I've been working on building a rear crossmember for a Land Rover Series 2A. I need to add the grab handle holes, a couple of other drain holes, and then gusset the rear section where the hitch mount comes through. Other than that, I think I'm looking pretty good. I had the outer sections to work from, but they were pretty rusty. It was enough to give me the dimensions I needed though. I pulled those dimensions into CAD and tried to cross reference some existing CAD drawings I had found of Land Rover rear crossmembers. They just didn't match, so I ended up building my own from the dimensions I took of my tub floor and the mounting strap hole locations. I then built a CAD (Cardboard Aided Design) version so I could confirm the inner bracing and all the details. Then I went back to my CAD model and made the necessary adjustments. I know I could probably buy one of these for a couple hundred bucks, but this would dip into the family budget and I have plenty of steel. Besides I've heard online that the reproduction ones are thin or they don't fit right. This will end up being a one to one version and I'll use the stock thickness of steel. I think it should end up fitting better if I just build it from scratch.
I've had a couple snow days so it kept me from getting into trouble in between shoveling the driveway.





















.jpg)
.jpg)
.jpg)


.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)



.jpg)




