On New Years Eve I worked on the Montesa Cota 247 reed valve engine that I have had sitting around forever. Before Christmas, I tried getting spark and fuel to it and discovered that I would get a loud backfire every time I tried to start it. The timing looked right and the points were set properly. I decided to pop the flywheel/mag off to see what the trouble was. It appears that the key was sheared and this allowed the mag to slip. It also appears that this happened a while ago; signs of all the rust on the area where the mag should have been seated. Yesterday, I cleaned out the remnants of the key and made a new key. I also lapped the shaft and mag to try and get things seated properly. Apparently this was a common problem on these bikes with shearing the key. I got everything back together and was able to get the 247 to pop over a few times. Now I think I need to double check timing and then figure out carb and exhaust sealing to insure to air leaks. The compression is strong on the motor so I believe this engine may have sat after the previous owner couldn't get it to run. Good for me, as I can get things set right and get back to riding it.
Showing posts with label cota. Show all posts
Showing posts with label cota. Show all posts
Wednesday, January 1, 2020
Tuesday, December 17, 2019
montesa trial 250
I have been very interested in the Montesa trials development and design since getting and restoring my first Montesa Cota 348 when I was in my late teens. I ran a Montesa Cota website for many years after teaching myself how to create and publish websites. Around this time I became aware of the Montesa Trial 250 which was the predecessor to the Cota series of motorcycles that were very successful in trials competition in the 70's. I remember thinking that it would be cool to create a sort of replica homage to those original prototypes and first production runs of Trial 250's.
My plan would be to take a early King Scorpion and add a later Cota flywheel to it and change the gearing. If the Scorpion was early enough it would allow you to run in an earlier trials class than most Cota's usually do. Jared Bates and I had had a few conversations about this at the time and he had a list of other mods that he thought would be slick.
I have since lost that list somewhere, but now that I'm in my new shop I spent a few hours yesterday modifying a King Scorpion frame to accept the reed valve conversion Cota motor that I've had sitting around. I had to cut out the frame tubes that run down from the main top tube and add in some spacers to make more room for the carb conversion. I also cut off the peg mounts and will relocate those farther back closer to the swingarm pivot and lower for stability. I mocked up an old tank and made a templet for some slide plate/seat combo that I'll make in aluminum. At this point, I'm just playing around, but this might actually turn into something if I keep going.
I just love the pics I of the early 250 I found that were taking in conjunction with the Montesa 50th anniversary. There is something really beautiful about this first trials prototype and production run. I'm always amazed when someone "gets it right" on the first try.
Labels:
250trial,
cota,
montesa,
montesa 250 trial,
observed trials,
prototype cota,
trials
Thursday, April 27, 2017
Tuesday, September 10, 2013
Subscribe to:
Posts (Atom)




































































